2KW SWITCH MODE POWER SUPPLIES - SM2000 Series

Features
19” Rack Construction
Wide Input Range
Equal Current Sharing Parallel Operation Possible
Abnormal Condition Alarm
Output Boost Facility

 
7 Segment Display for Voltage and Current Measurement

 
Power Factor Corrected (0.99 at full load) input available with PFC Prefix Modules
2KW Switch Mode Power Supplies - SM2000 Series
 
 
  
Aplab, 2kW power supply charger is the version of standard PSI-1100. These are combination of 2-PSI 1100 units connected in parallel. This gives the user the option of 2kW power in single module with all functions with the single operating mode.
  
Technical Specifications
Regulation Better than ±2%.
Ripple <200mV p-p.
Recovery Time 1ms typical.
Parallel Operation One or more units can be used in parallel for higher power capacity.
INPUT
Voltage 185 - 264 V AC, 45 - 65 Hz.
Current 16 Amps typical at 230V AC.
Power Factor 0.75 typical capacitive.
Spikes VDE 0843/IEC801-V-3-3.
Burst VDE 0843/IEC0801-IV-3-2.
RFI VDE 0878/EN55022-”A”.
PROTECTIONS
Over Voltage & Over Temp
Electronic turn off for output over-voltage and over-temperature, Reset through panel push switch.
Indications
LED Green = Float. LED Red = Boost. LED Red = Output Abnormal. 7 Segment DPM for output voltage & current measurement.